????

Your IP : 216.73.216.174

Current Path : /usr/local/src/plBake/MagickWandForPHP-1.0.9/
Upload File :
Current File : //usr/local/src/plBake/MagickWandForPHP-1.0.9/INSTALL

MagickWand Extension for PHP :: Installation Instructions

** REQUIRED **  ImageMagick version :: 6.3.5-9
Last-known-good ImageMagick version :: 6.3.5-9

Install without PHP source

1) Either install the required ImageMagick version or make sure that it
   is installed (running "Wand-config --version" should give you the
   required information).

2) Type

       phpize
       ./configure
       make
       make install

3) Add

       extension=magickwand.so

   to your "php.ini" initialization file.


Install with PHP Source

1) Either install the required ImageMagick version or make sure that it
   is installed (running "Wand-config --version" should give you the
   required information).

2) Extract the contents of the archive this file was in, or copy the
   entire directory the this file is in to the "ext" directory in the PHP
   source folder. Rename the folder to "magickwand" so if your PHP source
   folder is called "PHP_SRC_DIR", you should end up with a directory
   structure like the following:

       PHP_SRC_DIR/ext/magickwand/

3) Go into the "PHP_SRC_DIR/ext/magickwand/" directory, and run "phpize".
   (A note: if this is the first time PHP is being installed, you have to
   install PHP without MagickWand, because "phpize" is a part of the PHP
   distribution.)

4) Go back to the main PHP source directory (from the example above, it
   would be "PHP_SRC_DIR", and run:

   rm ./configure

   and then

   ./buildconf --force

   to remove and rebuild the PHP configure script.

5) Follow the PHP installation instructions, but add

   --with-magickwand=IMG_MGCK_DIR
   
   to your ./configure command, replacing "IMG_MGCK_DIR" with the full path
   of the directory where ImageMagick is installed (in most cases "/usr").